OTD140 – Router 4G para espacios exteriores

Descripción

MOBILE

• Mobile module4G (LTE) – LTE Cat 4 150 Mbps DL, 50 Mbps UL; 3G – 21 Mbps DL, 5.76 Mbps UL; 2G – 236.8 kbps DL, 236.8 kbps UL
• SIM switch2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection
• StatusIMSI, ICCID, operator, operator state, data connection state, network type, bandwidth, connected band, signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, data sent/received, LAC, TAC, cell ID, ARFCN, UARFCN, EARFCN, MCC, and MNC
• SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP
• USSDSupports sending and reading Unstructured Supplementary Service Data messages
• Black/White listOperator black/white list (by country or separate operators)
• Band managementBand lock, Used band status display
• APNAuto APN
• BridgeDirect connection (bridge) between mobile ISP and device on LAN
• PassthroughRouter assigns its mobile WAN IP address to another device on LAN

ETHERNET

• LAN2 x ETH ports (can be configured as WAN), 10/100 Mbps, compliance with IEEE 802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover

POE IN

• PoE ports1 x PoE In
• PoE standards802.3af/at

POE OUT

• PoE ports1 x PoE Out
• PoE standards802.3af Alternative B
• PoE Max Power per Port (at PSE)15 W Max (power supply unit dependent)

NETWORK

• RoutingStatic routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP), Policy based routing
• Network protocolsTCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SNMP, MQTT, Wake On Lan (WOL)
• VoIP passthrough supportH.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets
• Connection monitoringPing Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection
• FirewallPort forward, traffic rules, custom rules
• Firewall status pageView all your Firewall statistics, rules, and rule counters
• Ports managementView device ports, enable and disable each of them, turn auto-configuration on or off, change their transmission speed, and so on
• Network topologyVisual representation of your network, showing which devices are connected to which other devices
• DHCPStatic and dynamic IP allocation, DHCP relay, DHCP server configuration, status, static leases: MAC with wildcards
• QoS / Smart Queue Management (SQM)Traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e
• DDNSSupported >25 service providers, others can be configured manually
• Network backupVRRP, Wired options, each of which can be used as an automatic Failover
• HotspotCaptive portal (hotspot), internal/external Radius server, Radius MAC authentication, SMS authorisation, internal/external landing page, walled garden, user scripts, URL parameters, user groups, individual user or group limitations, user management, 9 default customisable themes and optionality to upload and download customised hotspot themes
• SSHFSPossibility to mount remote file system via SSH protocol

SECURITY

• AuthenticationPre-shared key, digital certificates, X.509 certificates, TACACS+, Radius, IP & login attempts block, time-based login blocking, built-in random password generator
• FirewallPre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T
• Attack preventionDDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks)
• VLANPort and tag-based VLAN separation
• Mobile quota controlMobile data limit, customizable period, start time, warning limit, phone number
• WEB filterBlacklist for blocking out unwanted websites, Whitelist for specifying allowed sites only
• Access controlFlexible access control of SSH, Web interface, CLI and Telnet

VPN

• OpenVPNMultiple clients and a server can run simultaneously, 27 encryption methods
• OpenVPN EncryptionDES-CBC 64, RC2-CBC 128, DES-EDE-CBC 128, DES-EDE3-CBC 192, DESX-CBC 192,BF-CBC 128, RC2-40-CBC 40, CAST5-CBC 128, RC2-64-CBC 64, AES-128-CBC 128, AES-128-CFB 128, AES-128-CFB1 128, AES-128-CFB8 128, AES-128-OFB 128, AES-128-GCM 128, AES-192-CFB 192, AES-192-CFB1 192, AES-192-CFB8 192, AES-192-OFB 192, AES-192-CBC 192, AES-192-GCM 192, AES-256-GCM 256, AES-256-CFB 256, AES-256-CFB1 256, AES-256-CFB8 256, AES-256-OFB 256, AES-256-CBC 256
• IPsecIKEv1, IKEv2, with 14 encryption methods for IPsec (3DES, DES, AES128, AES192, AES256, AES128GCM8, AES192GCM8, AES256GCM8, AES128GCM12, AES192GCM12, AES256GCM12, AES128GCM16, AES192GCM16, AES256GCM16)
• GREGRE tunnel, GRE tunnel over IPsec support
• PPTP, L2TPClient/Server instances can run simultaneously, L2TPv3, L2TP over IPsec support
• StunnelProxy designed to add TLS encryption functionality to existing clients and servers without any changes in the program’s code
• DMVPNMethod of building scalable IPsec VPNs
• SSTPSSTP client instance support
• ZeroTierZeroTier VPN client support
• WireGuardWireGuard VPN client and server support
• TincTinc offers encryption, authentication and compression in it’s tunnels. Client and server support.

OPC UA

• Supported modesClient, Server
• Supported connection typesTCP

MODBUS

• Supported modesServer, Client
• Supported connection typesTCP
• Custom registersMODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Client functionality
• Supported data formats8-bit: INT, UINT; 16-bit: INT, UINT (MSB or LSB first); 32-bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII

DATA TO SERVER

• ProtocolHTTP(S), MQTT, Azure MQTT
• Data to serverExtract parameters from multiple sources and different protocols, and send them all to a single server

MQTT GATEWAY

• Modbus MQTT GatewayAllows sending commands and receiving data from MODBUS Server through MQTT broker

DNP3

• Supported modesStation, Outstation
• Supported connectionTCP

DLMS

• DLMS SupportDLMS – standard protocol for utility meter data exchange

API

• Teltonika Networks Web API (beta) supportExpand your device’s possibilities by using a set of configurable API endpoints to retrieve or change data. For more information, please refer to this documentation: https://developers.teltonika-networks.com

MONITORING & MANAGEMENT

• WEB UIHTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, multiple event log servers, firmware update availability notifications, event log, system log, kernel log, Internet status
• FOTAFirmware update from server, automatic notification
• SSHSSH (v1, v2)
• EmailReceive email message status alerts of various services
• SMSSMS status, SMS configuration, send/read SMS via HTTP POST/GET
• CallReboot, Status, Mobile data on/off, Output on/off, answer/hang-up with a timer
• TR-069OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem
• MQTTMQTT Broker, MQTT publisher
• SNMPSNMP (v1, v2, v3), SNMP Trap
• JSON-RPCManagement API over HTTP/HTTPS
• RMSTeltonika Remote Management System (RMS)

IOT PLATFORMS

• Cloud of ThingsAllows monitoring of: Device data, Mobile data, Network info, Availability
• ThingWorxAllows monitoring of: WAN Type, WAN IP, Mobile Operator Name, Mobile Signal Strength, Mobile Network Type
• CumulocityAllows monitoring of: Device Model, Revision and Serial Number, WAN Type and IP, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength
• Azure IoT HubCan send device IP, Number of bytes send/received, Temperature, PIN count to Azure IoT Hub server, Mobile connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, SIM State, PIN state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type

SYSTEM CHARACTERISTICS

• CPUMediatek, 580 MHz, MIPS 24KEc
• RAM128 MB
• FLASH storage16 MB

FIRMWARE / CONFIGURATION

• WEB UIUpdate FW from file, check FW on server, configuration profiles, configuration backup
• FOTAUpdate FW
• RMSUpdate FW/configuration for multiple devices at once
• Keep settingsUpdate FW without losing current configuration
• Factory settings resetA full factory reset restores all system settings, including the IP address, PIN, and user data to the default manufacturer’s configuration

FIRMWARE CUSTOMISATION

• Operating systemRutOS (OpenWrt based Linux OS)
• Supported languagesBusybox shell, Lua, C, C++, and Python, Java in Package manager
• Development toolsSDK package with build environment provided
• GPL customizationYou can create your own custom, branded firmware and web page application by changing colours, logos, and other elements in our firmware to fit your or your clients’ needs

POWER

• ConnectorRJ45 Socket
• Input voltage range42.5–57.0 VDC, reverse polarity protection, voltage surge/transient protection
• Input voltage range for PoE42.5–57.0 VDC, reverse polarity protection, voltage surge/transient protection
• Power consumptionIdle: < 2.5 W / Max: < 6 W / PoE Max < 21 W

PHYSICAL INTERFACES

• Ethernet2 x RJ45 ports, 10/100 Mbps
• Status LEDs3 x Mobile connection type, 3 x Mobile connection strength, 4 x ETH status LEDs
• SIM2 x SIM slots (Mini SIM – 2FF), 1.8 V/3 V
• PowerRJ45, PoE In, 42.5 – 57.0 VDC
• Antennas2 x Internal antennas
• Antennas specifications1 x 698 – 960 / 1710 – 2690MHz, 50 Ω, VSWR <3.5, gain <3 dBi, omnidirectional1 x 698 – 960 / 1710 – 2690MHz, 50 Ω, VSWR <3, gain <4.5 dBi, omnidirectional
• ResetReboot/User default reset/Factory reset button

PHYSICAL SPECIFICATION

• Casing materialPlastic (PC+ASA)
• Dimensions (W x H x D)110 x 49.30 x 235 mm
• Weight855 g
• Mounting optionsMounting bracket (for vertical flat surface or pole mounting)

OPERATING ENVIRONMENT

• Operating temperature-40 °C to 75 °C
• Operating humidity10% to 90% non-condensing
• Ingress Protection RatingIP55

REGULATORY & TYPE APPROVALS

• RegulatoryCE, UKCA, EAC, UCRF, RCM